How to Proceed With Troubleshooting

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
- The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP
NEXT -- Continue to next step.

2. CUSTOMER PROBLEM ANALYSIS
NEXT -- Continue to next step.

3. INSPECT BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT -- Continue to next step.

4. CONNECT TECHSTREAM TO DLC3*
NEXT -- Continue to next step.

5. CHECK AND CLEAR DTCs AND FREEZE FRAME DATA*
(a) Refer to the DTC Check / Clear DTC Check / Clear.
NEXT -- Continue to next step.

6. VISUAL INSPECTION
NEXT -- Continue to next step.

7. SETTING CHECK MODE DIAGNOSIS*
(a) Refer to the Check Mode Procedure Check Mode Procedure.
NEXT -- Continue to next step.

8. PROBLEM SYMPTOM CONFIRMATION
(a) Refer to the Road Test Road Test.

Result





B -- GO TO STEP 10
A -- Continue to next step.

9. SYMPTOM SIMULATION
(a) Refer to the Electronic Circuit Inspection Procedure Electronic Circuit Inspection Procedure.
NEXT -- Continue to next step.

10. DTC CHECK*
(a) Refer to the DTC Check / Clear DTC Check / Clear.

Result





B -- GO TO STEP 18
A -- Continue to next step.

11. BASIC INSPECTION
(a) Refer to the Automatic Transmission Fluid Procedures.
(b) Refer to the Park/Neutral Position Switch On-Vehicle Inspection.
(c) Refer to the Shift Lever Assembly On-Vehicle Inspection.

NG -- GO TO STEP 21
OK -- Continue to next step.

12. MECHANICAL SYSTEM TESTS
(a) Refer to the Mechanical System Tests Mechanical System Tests.

NG -- GO TO STEP 17
OK -- Continue to next step.

13. HYDRAULIC TEST
(a) Refer to the Hydraulic Test Hydraulic Test.

NG -- GO TO STEP 17
OK -- Continue to next step.

14. MANUAL SHIFTING TEST
(a) Refer to the Manual Shifting Test Manual Shifting Test.

NG -- GO TO STEP 16
OK -- Continue to next step.

15. PROBLEM SYMPTOMS TABLE CHAPTER 1
(a) Refer to the Problem Symptoms Table Symptom Related Diagnostic Procedures.

NG -- GO TO STEP 19
OK -- Continue to next step.

16. PROBLEM SYMPTOMS TABLE CHAPTER 2
(a) Refer to the Problem Symptoms Table Symptom Related Diagnostic Procedures.
NEXT -- Continue to next step.

17. PART INSPECTION

NG -- GO TO STEP 21
OK -- Continue to next step.

18. DTC CHART
(a) Refer to the Diagnostic Trouble Code Chart Automatic Transmission System - AB60F.
NEXT -- Continue to next step.

19. CIRCUIT INSPECTION
NEXT -- Continue to next step.

20. IDENTIFICATION OF PROBLEM
NEXT -- Continue to next step.

21. REPAIR OR REPLACE
NEXT -- Continue to next step.

22. CONFIRMATION TEST
NEXT -- END