Canada - Interior - Condensation Drips From Dome Lamp Cover

Bulletin
TSB3247

Issue Date
September 9, 2009

Market
Canada

Title
WATER CONDENSATION DRIPPING FROM AROUND DOME LIGHT COVER (ACCESS CAB ONLY)

Component
BODY COMPONENTS

Models
'09 Tacoma

INTRODUCTION:
Some 2009 Tacoma vehicles may exhibit a condition where dampness or water drips from the headliner around the dome light cover. This condition is caused by condensation forming in the space between the headliner and the roof of the vehicle. Use the following repair procedure to correct this condition.






APPLICABILITY:






WARRANTY INFORMATION:






PARTS INFORMATION:






REQUIRED TOOLS & EQUIPMENT:

NOTE:
Additional SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.

REPAIR PROCEDURE:
1. Remove headliner.
For headliner removal and installation instructions, Refer to the Repair Manual within E-TAS / TIS library:
- Division: Toyota
- Model: Tacoma
- Year: 2009
- Service Category: Vehicle Interior
- Section: Interior Panels/Trim
- Keyword: Roof Headlining (Access Cab): Removal/ Installation

2. Dry the roof panel with a towel.

NOTE:
To ensure proper adhesion of the NEW roof silencer pad, all moisture must be removed.







3. Attach the two pieces of Roof Silencer Pad (P/N 63342-04020) next to the existing Roof Silencer Pads.
4. Reinstall headliner and all other interior components.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.