Turn Signal Flasher: Testing and Inspection

LIGHTING: TURN SIGNAL FLASHER ASSEMBLY: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT TURN SIGNAL FLASHER ASSEMBLY (w/o Daytime Running Light System)
(a) Check the power source circuit and ground circuit.
(1) Remove the turn signal flasher assembly from the instrument panel junction block assembly.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.





Standard:





(3) Measure the resistance and check the result in accordance with the value(s) in the table below.
Standard:










(b) Check the output operation signal.
(1) Install the turn signal flasher assembly onto the instrument panel junction block assembly.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.
Standard:






2. INSPECT TURN SIGNAL FLASHER ASSEMBLY (w/ Daytime Running Light Control)





(a) Check the power source circuit and ground circuit.
(1) Disconnect the connector from the turn signal flasher assembly.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.
Standard:





(3) Measure the resistance and check the result in accordance with the value(s) in the table below.
Standard:






(b) Check the output operation signal.




(1) Connect the connector to the turn signal flasher assembly.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.
Standard: