Removal

STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column): REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE UPPER STEERING COLUMN COVER





(a) Remove the 2 screws.
HINT: Turn the steering wheel to the right and left as necessary to remove the 2 screws.





(b) Detach the 4 clips.
(c) Detach the claw to remove the upper steering column cover.





3. REMOVE LOWER STEERING COLUMN COVER
(a) Detach the 2 claws to remove the lower steering column cover.
4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Removal
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Removal
6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT Removal
7. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY Removal





8. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the 2 ECU connectors.
(b) Remove the 2 screws and ECU.