Removal

2UZ-FE ENGINE CONTROL SYSTEM: CAMSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. DRAIN ENGINE COOLANT Service and Repair
3. REMOVE DRIVE BELT Removal
4. DISCONNECT NO. 1 RADIATOR HOSE
5. REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH Removal
6. REMOVE CAMSHAFT POSITION SENSOR





(a) Remove the bolt, stud bolt and camshaft position sensor.