Removal

A750E AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Removal

3. REMOVE REAR ENGINE UNDER COVER ASSEMBLY Removal

4. REMOVE FRONT FENDER APRON SEAL RH Removal

5. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH Removal

6. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

7. REMOVE PROPELLER SHAFT ASSEMBLY

(a) Remove the propeller shaft Removal.

8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the front exhaust pipe Removal.

9. REMOVE MANIFOLD STAY





(a) Remove the 3 bolts and stay.

10. REMOVE NO. 2 MANIFOLD STAY





(a) Remove the 3 bolts and stay.

11. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Remove the nut and clip, and disconnect the transmission control cable from the transmission.

12. DISCONNECT NO. 1 OIL COOLER INLET TUBE AND NO. 1 OIL COOLER OUTLET TUBE





(a) Remove the 2 bolts to open the 2 No. 2 flexible hose clamps.

(b) Using a union nut wrench, disconnect the inlet tube and outlet tube from each oil cooler tube union.

13. REMOVE STARTER ASSEMBLY

(a) Remove the starter Removal.

14. REMOVE DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT





(a) Remove the flywheel housing side cover.

(b) Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.





15. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY





(a) Support the transmission with a transmission jack. Lift the transmission slightly from the crossmember.

16. REMOVE FRONT SUSPENSION MEMBER BRACKET LH AND RH (for X-Runner)





(a) Remove the 8 bolts and front suspension member bracket LH and RH.

17. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY





(a) Remove the 4 bolts of the rear engine mounting insulator.

(b) Remove the 4 nuts, 4 bolts and frame crossmember.





18. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR





(a) Remove the bolt and rear engine mounting heat insulator.

(b) Remove the 4 bolts and rear engine mounting insulator from the transmission.

19. DISCONNECT WIRE HARNESS AND CONNECTOR

(a) Tilt the transmission downward.





NOTICE:
Make sure the cooling fan does not contact the fan shroud.

(b) Disconnect the park/neutral position switch connector, transmission wire connector and 2 speed sensor connectors.

HINT
Detach the claw, press down the lever, and then disconnect the transmission wire connector.





(c) Detach the 2 connector clamps and 4 harness clamps, and disconnect the wire harness.

20. DISCONNECT BREATHER PLUG HOSE





(a) Disconnect the breather plug hose from the engine side.

21. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY





(a) Remove the 9 bolts and automatic transmission.

NOTICE:
Do not use excess force when prying the transmission assembly.

22. REMOVE HARNESS CLAMP BRACKET





(a) Remove the 4 bolts and 4 harness clamp brackets.

23. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET





(a) Remove the 2 bolts and transmission control cable bracket.

24. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY

25. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

(a) Inspect the torque converter clutch Testing and Inspection.