Removal

2GR-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL

1. REMOVE V-BANK COVER SUB-ASSEMBLY

2. REMOVE ENGINE UNDER COVER ASSEMBLY

3. REMOVE NO. 1 ENGINE UNDER COVER

4. DRAIN ENGINE COOLANT

5. REMOVE COOL AIR INTAKE DUCT SEAL

6. REMOVE BATTERY

7. REMOVE NO. 2 AIR CLEANER INLET

8. REMOVE NO. 1 AIR CLEANER INLET

9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

11. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the engine coolant temperature sensor connector.





(b) Remove the engine coolant temperature sensor and gasket.