C1268

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1268/68: Transfer "L4" Position Switch Circuit
C1268/68 - Transfer "L4" Position Switch Circuit

DESCRIPTION

After confirming that the transfer is in the L4 position, CRAWL will be activated according to the vehicle conditions.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration Programming and Relearning.

PROCEDURE

1. CHECK CAN COMMUNICATION LINE

(a) Turn the engine switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the engine switch on (IG) and the Techstream on.

(d) Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.

OK:

"CAN Bus Check" indicates no malfunctions in CAN communication.

NG -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Initial Inspection and Diagnostic Overview
OK -- Continue to next step.

2. CHECK DTC (CAN COMMUNICATION SYSTEM)

(a) Turn the engine switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the engine switch on (IG) and the Techstream on.

(d) Check for DTCs Initial Inspection and Diagnostic Overview.

Result





B -- GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) CAN Communication System

A -- GO TO TRANSFER SYSTEM (INSPECTION)