Rear View Monitor System

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: Display Signal Circuit between Multi-display and Television Camera Assembly
- Display Signal Circuit between Multi-display and Television Camera Assembly

DESCRIPTION

This is the display signal circuit of the rear television camera.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK REAR TELEVISION CAMERA ASSEMBLY





(a) Using an oscilloscope, check the waveform.

Measurement Condition





Text in illustration





OK:

Pulse generation

NG -- REPLACE REAR TELEVISION CAMERA ASSEMBLY Removal
OK -- Continue to next step.

2. CHECK MULTI-DISPLAY





(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- REPLACE MULTI-DISPLAY Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - REAR TELEVISION CAMERA)

(a) Disconnect the F49 multi-display connector.

(b) Disconnect the S5 camera connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Rear View Monitor System