Removal

3UR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

(a) Remove the automatic transmission Removal.

3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Removal

4. REMOVE REAR CRANKSHAFT OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.

(b) Using a screwdriver, pry out the oil seal.





HINT
Tape the screwdriver tip before use.

NOTICE:
Do not damage the surface of the oil seal press fit hole and crankshaft.