Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2010 >> Landcruiser V8-5.7L (3UR-FE) >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation





3UR-FE ENGINE CONTROL: ECM: INSTALLATION

1. INSTALL GASKET

(a) Clean the ECM seal surface with non-residue solvent.

(b) Attach a new gasket to the ECM.

2. INSTALL ECM

(a) Install the ECM with the 4 bolts.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

NOTICE:
* Make sure the gasket is not folded or caught on any area of the surrounding part.
* Make sure there is no foreign matter caught between the gasket and surrounding part.
* Do not damage the gasket.
(b) Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.





NOTICE:
* Be careful not to allow dirt, water, or other foreign matter to adhere to the connecting parts when connecting the connectors.
* Do not twist the wire harness when connecting the ECM connectors.
* Make sure that the lock levers are raised 90° before connecting the ECM connectors. Failure to do this may cause the lock lever and terminals to break.
* Make sure that the levers are securely locked.
3. INSTALL CONNECTOR HOLDER BLOCK

(a) Install the connector holder block with the 3 bolts.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
pro multis · About Operation CHARM