Repair Instruction - Customize Parameters

INTRODUCTION: REPAIR INSTRUCTION: CUSTOMIZE PARAMETERS

HINT
The following items can be customized.

NOTICE:
* When the customer requests a change in a function, first make sure that the function can be customized.
* Be sure to make a note of the current settings before customizing.
* When troubleshooting a function, first make sure that the function is set to the default setting.

1. CUSTOMIZING FUNCTION WITH TECHSTREAM

(a) POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

Tilt & Telesco

(b) INTUITIVE PARKING ASSIST SYSTEM

Warning

Sensor

Display

(d) WIRELESS DOOR LOCK CONTROL SYSTEM

Wireless Door Lock

(e) SMART KEY SYSTEM (for Entry Function)

Smart Key / Access

Warning

HINT
*1: Waiting time to permit unlocking door after locking.

*2: Entry ignition available area.

*3: "FRONT" means front, and "ALL" means front, rear 1 and rear 2.

*4: Back door open mode when vehicle is locked.

*5: Warn when key battery becomes weak.

(f) ENTRY UNLOCK MODE SWITCHING FUNCTION

(1) To use the entry unlock mode switching function, make sure the engine switch is off and simultaneously press and hold the lock switch on the key and another key switch for 5 seconds.

When the switches are pressed and held for 5 seconds, the entry door unlock mode changes in the following order: driver door unlock mode, all door unlock mode.

NOTICE:
After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.

Driver door unlock mode (default):

When the driver door touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.

All door unlock mode:

When a touch sensor is touched, all doors unlock.

(2) The certification ECU (smart key ECU assembly) receives this signal from the door control receiver and changes the smart key system to the entry unlock mode.

(3) The certification ECU (smart key ECU assembly) sounds the wireless door lock buzzer and combination meter buzzer to inform the user that the mode has been switched.

HINT
The function only changes the entry unlock mode of the smart key system. It does not switch the unlocking of the wireless door lock control.

Driver door unlock mode:

All door unlock mode:

(g) KEY CANCEL

The key cancel operation disables the following functions:

Entry Unlock/Lock

Key Lock-in Prevention

Memory Call

Entry Back Door Open

Warning

Entry Ignition

(1) The operation procedures are as follows:

Precondition:

Engine switch off, driver side door closed and unlocked.

Unlock the driver side door once with the unlock switch of the key.

Open the driver door within 5 seconds.

Unlock the driver side door twice with the unlock switch of the key within 5 seconds.

Perform close -> open twice for the driver door within 30 seconds.

(Driver door: Open condition -> Close -> Open -> Close -> Open)

Unlock the driver side door twice with the unlock switch of the key within 5 seconds.

Perform close -> open once for the driver door within 30 seconds.

(Driver door: Open condition -> Close -> Open)

Close the driver door within 5 seconds.

When key cancel is activated, the wireless door lock buzzer sounds twice.

To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.

(h) SMART KEY SYSTEM (for Start Function)

Smart Key / Access