Installation

PARK ASSIST / MONITORING: ULTRASONIC SENSOR: INSTALLATION

1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

(a) Temporarily install the No. 1 ultrasonic sensor retainer to the front bumper.









NOTICE:
* Do not damage the front bumper with the protrusion when installing the retainer.
* Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.
HINT
When installing the retainer, align the keyhole and protrusion as shown in the illustration.

(b) Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper.





HINT
Use the same procedure for the RH side and LH side.

2. INSTALL NO. 1 ULTRASONIC SENSOR

(a) Engage the 2 claws to install the No. 1 ultrasonic sensor as shown in the illustration.





NOTICE:
Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

(b) Engage the 4 claws to connect the wire harness with bracket.





(c) Connect the connector.

HINT
Use the same procedure for the RH side and LH side.

3. INSTALL FRONT BUMPER ASSEMBLY Installation

4. INSTALL RADIATOR SUPPORT OPENING COVER Installation

5. ADD WASHER FLUID (w/ Headlight Cleaner System) Installation

6. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT Adjustments

7. PREPARE FOR FOG LIGHT AIMING Adjustments

8. INSPECT FOG LIGHT AIMING Adjustments

9. ADJUST FOG LIGHT AIMING Adjustments