Rear View Monitor System (w/ Navigation System)

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/ Navigation System): HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use the following procedure to troubleshoot the rear view monitor system.
* *: Use the Techstream.
1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. CUSTOMER PROBLEM ANALYSIS

NEXT -- Continue to next step.

3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage with the power switch off.

Standard Voltage:

11 to 14 V

(b) If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT -- Continue to next step.

4. PROBLEM SYMPTOM CONFIRMATION





B -- Go to step 6
A -- Continue to next step.

5. SYMPTOM SIMULATION

NEXT -- Continue to next step.

6. CHECK DTC*

(a) Check for DTCs and note any codes that are output Rear View Monitor System (w/ Navigation System).

(b) Clear the DTC Rear View Monitor System (w/ Navigation System).

(c) Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

NOTICE:
The navigation receiver assembly may output the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.









B -- Go to step 8

C -- GO TO NAVIGATION SYSTEM
A -- Continue to next step.

7. DIAGNOSTIC TROUBLE CODE CHART*

(a) Refer to Diagnostic Trouble Code Chart Rear View Monitor System (w/ Navigation System).

NEXT -- Go to step 10

8. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.





B -- Go to step 9
A -- Continue to next step.

9. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

(a) Refer to Terminals of ECU Rear View Monitor System (w/ Navigation System).

NEXT -- Continue to next step.

10. CIRCUIT INSPECTION

NEXT -- Continue to next step.

11. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

12. CONFIRMATION TEST

NEXT -- END