Procedures

P410 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE FLUID: REPLACEMENT

1. DRAIN HYBRID TRANSAXLE FLUID

(a) Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.









(b) Using a 10 mm hexagon socket wrench, remove the drain plug and gasket.

(c) Using a 10 mm hexagon socket wrench, install the drain plug, and a new gasket.

Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

2. ADD HYBRID TRANSAXLE FLUID

(a) Add transaxle fluid until the fluid level is between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening.





NOTICE:
* Stop the vehicle on a flat road.
* Recheck the transaxle fluid level after driving when exchanging fluid.
* Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

Reference:

3.4 liters (3.6 US qts, 3.0 Imp.qts)

3. INSPECT HYBRID TRANSAXLE FLUID

(a) Check that the fluid level is between 0 to 10 mm (0 to 0.394 in.) from the lowest position of the inner surface of the transaxle filler plug opening.





NOTICE:
* Stop the vehicle on a flat road.
* Recheck the transaxle fluid level after driving when exchanging fluid.
* Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.
(b) Check for leaks if the quantity of transaxle fluid is low.

(c) Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.

Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)