B1610

SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: B1610/13: Front Airbag Sensor RH Circuit Malfunction
B1610/13 - Front Airbag Sensor RH Circuit Malfunction

DESCRIPTION

The front airbag sensor RH consists of the diagnostic circuit, the frontal deceleration sensor, etc.

If the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether or not the SRS should be activated.

DTC B1610/13 is recorded when a malfunction is detected in the front airbag sensor RH circuit.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK FRONT AIRBAG SENSOR RH





(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(c) Interchange the front airbag sensor RH and LH, and connect the connectors to them.

(d) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

(e) Turn the ignition switch to ON, and wait for at least 60 seconds.

(f) Clear the DTCs DTC Check / Clear.

(g) Turn the ignition switch off.

(h) Turn the ignition switch to ON, and wait for at least 60 seconds.

(i) Check the DTCs DTC Check / Clear.





HINT
DTCs other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

C -- REPLACE FRONT AIRBAG SENSOR RH

B -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY

A -- USE SIMULATION METHOD TO CHECK

2. USE SIMULATION METHOD TO CHECK

3. REPLACE CENTER AIRBAG SENSOR ASSEMBLY

4. REPLACE FRONT AIRBAG SENSOR RH