C2115

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2111/11-C2115/15: Transmitter ID1 Operation Stop
C2115/15 - Transmitter ID5 Operation Stop

DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the air pressure of the tires. The measured values are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter comes on. The tire pressure warning ECU stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. At this time, forcibly transmit the signals by releasing the tire pressure rapidly. The stored DTC is cleared when the signal transmission is resumed.





HINT
It is necessary to perform the procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
It is necessary to register the transmitter IDs after replacing the tire pressure warning valve and transmitter and/or the tire pressure warning ECU Programming and Relearning.

PROCEDURE

1. PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS

(a) Set the tire pressure of all the wheels to the specified value Service Precautions.

(b) Turn the ignition switch off.

(c) Connect the Techstream to the DLC3.

(d) Turn the ignition switch ON.

(e) Turn the Techstream on.

(f) Confirm that the data of tire pressure of all the tires (including the spare tire) are displayed on the Techstream display. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Tire Pressure Monitor:





HINT
*1: It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 C2121.

(g) Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

(1) Check that each tire pressure data displayed on the Techstream display has changed.

OK:

Each tire pressure data displayed on the Techstream display will change to the value of the tire pressure.

NOTICE:
* It takes about 2 or 3 minutes to display the updated tire pressure data.
* If "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees (including the spare tire). Then rapidly reduce the tire pressure and recheck it.

(2) After confirming that all of the tire pressure data displayed on the Techstream display has changed, set the tire pressure to the appropriate specified values.

HINT
If the tire pressure data displayed on the Techstream display has not changed after rechecking, inspect for another problem C2121.

NG -- GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE C2121

OK -- END