Lost Communication with Driver Side - Side Airbag Sensor Assembly - Airbag System

SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: B1622/81: Lost Communication with Driver Side - Side Airbag Sensor Assembly
B1622/81 - Lost Communication with Driver Side - Side Airbag Sensor Assembly

DESCRIPTION

The side airbag sensor LH consists of part including the diagnostic circuit and the lateral deceleration sensor.

When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.

DTC B1622/81 is set when a malfunction is detected in the side airbag sensor LH circuit.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK CONNECTION OF CONNECTOR

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(c) Check that the connectors are properly connected to the center airbag sensor, rear airbag sensor LH and the side airbag sensor LH.

OK:

The connectors are properly connected.

NG -- CONNECT CONNECTOR
OK -- Continue to next step.

2. CHECK FLOOR WIRE (OPEN)





(a) Disconnect the connectors from the center airbag sensor and the side airbag sensor LH.

(b) Using a service wire, connect K9-4 (BBL+) and K9-3 (BBL-) of connector C.

NOTICE:
Do not forcibly insert the service wire into the terminals of the connector when connecting.

(c) Measure the resistance of the wire harness side connector.

Standard resistance:





NG -- REPAIR OR REPLACE FLOOR WIRE
OK -- Continue to next step.

3. CHECK FLOOR WIRE (SHORT)





(a) Disconnect the service wire from connector C.

(b) Measure the resistance of the wire harness side connector.

Standard resistance:





NG -- REPAIR OR REPLACE FLOOR WIRE
OK -- Continue to next step.

4. CHECK FLOOR WIRE (TO B+)





(a) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

(b) Turn the ignition switch to ON.

(c) Measure the voltage of the wire harness side connector.

Standard voltage:





NG -- REPAIR OR REPLACE FLOOR WIRE
OK -- Continue to next step.

5. CHECK FLOOR WIRE (TO GROUND)





(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(c) Measure the resistance of the wire harness side connector.

Standard resistance:





NG -- REPAIR OR REPLACE FLOOR WIRE
OK -- Continue to next step.

6. CHECK SIDE AIRBAG SENSOR LH





(a) Connect the connectors to the center airbag sensor.

(b) Interchange the side airbag sensor RH with the side airbag sensor LH and connect the connectors to them.

(c) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

(d) Turn the ignition switch to ON, and wait for at least 60 seconds.

(e) Clear the DTCs DTC Check / Clear.

(f) Turn the ignition switch off.

(g) Turn the ignition switch to ON, and wait for at least 60 seconds.

(h) Check for DTCs DTC Check / Clear.

Result





HINT
DTCs other than DTC B1622/81 and B1627/82 may be output at this time, but they are not related to this check.

C -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY

B -- REPLACE SIDE AIRBAG SENSOR LH

A -- USE SIMULATION METHOD TO CHECK