Reassembly

SLIDING ROOF: SLIDING ROOF HOUSING: REASSEMBLY

1. INSTALL SLIDING ROOF DRIVE CABLE





(a) Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them.

HINT
Tape the screwdriver tip before use.





(b) Engage the 2 claws and install the sliding roof drip channel.





(c) Install the 2 sliding roof side stoppers with the 2 screws.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

2. ADJUST FULLY CLOSED POSITION





(a) Using a screwdriver, slide the sliding roof drive cable LH and RH to align the matchmarks.

HINT
Tape the screwdriver tip before use.

3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY





(a) Insert the sunshade trim into the sliding roof housing.

4. INSTALL SLIDING ROOF DRAIN HOSE JOINT LH





(a) Install the joint with the screw.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

5. INSTALL SLIDING ROOF DRAIN HOSE JOINT RH

HINT
Use the same procedures described for the LH side.

6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY





(a) Install the drive gear with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)





(b) Attach the claw and install the sliding roof drive gear bracket.