Removal

SEAT: REAR NO. 2 SEAT ASSEMBLY: REMOVAL

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the RH side.
1. REMOVE NO. 2 SEAT HINGE COVER LH

(a) Fully tilt the seatback forward.

(b) Attach the 2 claws and clip.





(c) Pull the hinge cover in the direction indicated by the arrow in the illustration to detach the 2 claws. Then, remove the hinge cover.





2. REMOVE NO. 2 SEAT LEG COVER LH

(a) Using a screwdriver, detach the 5 claws and remove the leg cover.





HINT
Tape the screwdriver tip before use.

3. REMOVE REAR NO. 2 SEAT ASSEMBLY

(a) Remove the nut and rear seat cushion wire.





(b) Remove the 2 bolts. Then disconnect the seat from the rear No. 2 seat link.

(c) Remove the 2 nuts and the rear No. 2 seat link.





(d) Pull the lock release band backward and release the 3 seat cushion locks from the lock strikers.





(e) Lift up and remove the seat.

NOTICE:
Be careful not to damage the vehicle body,

4. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

5. REMOVE NO. 2 SEAT LEG BOX PROTECTOR.

(a) Using a clip remover, remove the clip.





(b) Detach the clip. Then remove the protector.