Check For Intermittent Problems

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: CHECK FOR INTERMITTENT PROBLEMS

1. CHECK FOR INTERMITTENT PROBLEMS

HINT
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected by using the ECU Data List function of the Techstream.

(a) Turn the ignition switch off and connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Follow the prompts on the Techstream to display the Data List and select areas where a momentary interruption should be monitored.





HINT
* A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
* If the status remains on the Error display, check for continuity between the ECU and the sensors, or between ECUs.
* The Error display on the Techstream remains on for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal condition.






(d) While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs. If the display changes, the connector and/or wire harness is in momentary interruption (open circuit). Repair or replace the connector and/or wire harness, as one of them is faulty.