Diagnosis System

CRUISE CONTROL: CRUISE CONTROL SYSTEM: DIAGNOSIS SYSTEM

1. DESCRIPTION

The ECM controls the function of cruise control on this vehicle. Data of the cruise control or DTC can be read from the DLC3 of the vehicle. When trouble occurs with cruise control, check that the CRUISE main indicator does not come on but DTC inspection is performed.

Therefore, when there seems to be a problem with the cruise control, use the Techstream or SST to check and troubleshoot it.

2. CHECK DLC3

(a) The ECM uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.









NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, other switches or doors.

(b) If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT
Connect the cable of the Techstream to the DLC3, turn the ignition switch ON and attempt to use the Techstream. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the Techstream.

* If communication is normal when the Techstream is connected to another vehicle, inspect the DLC3 of the original vehicle.
* If communication is still not possible when the Techstream is connected to another vehicle, the problem may be in the Techstream itself. Consult the Service Department listed in the Techstream's instruction manual.
3. CHECK INDICATOR

(a) Turn the ignition switch ON.





(b) Check that the CRUISE main indicator light illuminates when the cruise control main switch is turned ON, and that the indicator light goes off when the main switch is turned OFF.

HINT
* If the indicator check result is not normal, proceed to troubleshooting for the combination meter section How To Proceed With Troubleshooting.
* If a malfunction occurs in the speed sensor or stop light switch, etc. during cruise control driving, the ECM activates the AUTO CANCEL of the cruise control and the CRUISE main indicator light blinks to inform the driver of a malfunction. At the same time, the malfunction is stored in memory as a diagnostic trouble code.