Installation

OTHER SYSTEM: VOLTAGE INVERTER: INSTALLATION

1. INSTALL VOLTAGE INVERTER ASSEMBLY

(a) Attach the claw to install the voltage inverter assembly.





(b) Temporarily install the 2 bolts, and then tighten them in the order shown in the illustration.

Torque : 8.4 Nm (85 kgf-cm, 74 in-lbf)

(c) Connect the connector.

2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (w/o Rear No. 2 Seat) Installation

3. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. Seat) Installation

5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

6. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat) Installation

7. INSTALL REAR FLOOR FINISH PLATE Removal

8. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE Removal

9. INSTALL REAR FLOOR NO. 3 BOARD

10. INSTALL REAR FLOOR NO. 2 BOARD

11. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

12. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

13. INSTALL NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) Installation

14. INSTALL NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

15. INSTALL NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) Installation

16. INSTALL NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

17. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

18. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)

19. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

20. INSTALL REAR DOOR SCUFF PLATE LH Installation