Installation

2AR-FE ENGINE CONTROL SYSTEM: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)





(a) Using SST, install the sensor to the front exhaust pipe.

SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

HINT
* Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
* Make sure SST and wrench are connected in a straight line.
(b) Connect the sensor connector.

2. INSPECT FOR EXHAUST GAS LEAK