Removal

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: REMOVAL

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE REAR DOOR SCUFF PLATE LH Removal

3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

4. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/o Rear No. 2 Seat)

5. REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat)

6. REMOVE REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)

7. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

8. REMOVE NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) Removal

9. REMOVE NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat) Removal

10. REMOVE NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) Removal

11. REMOVE NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat) Removal

12. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) Removal

13. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat) Removal

14. REMOVE REAR FLOOR NO. 2 BOARD

15. REMOVE REAR FLOOR NO. 3 BOARD

16. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE Removal

17. REMOVE BACK DOOR WEATHERSTRIP

18. REMOVE REAR FLOOR FINISH PLATE

19. REMOVE REAR DECK TRIM COVER (w/ Rear No. 2 Seat)

20. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH (w/o Rear No. 2 Seat)

21. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH Removal

22. DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (w/ Rear No. 2 Seat) Removal

23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. 2 Seat) Removal

24. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat) Removal

25. REMOVE AIRBAG SENSOR REAR LH





(a) Disconnect the connector.

(b) Remove the bolt and airbag sensor.