Installation

SUSPENSION: FRONT LOWER BALL JOINT: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH

(a) Install the ball joint with the 2 bolts and nut to the lower arm.

Torque : 92 Nm (938 kgf-cm, 68 ft-lbf)

(b) Install the lower ball joint with the nut to the steering knuckle.

Torque : 133 Nm (1,360 kgf-cm, 98 ft-lbf)

(c) Install a new cotter pin.

* If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

2. INSTALL STEERING KNUCKLE WITH AXLE HUB Installation

3. CONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH Installation

4. CONNECT TIE ROD END SUB-ASSEMBLY LH Installation

5. INSTALL FRONT DISC Reassembly

6. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH Installation

7. INSTALL FRONT AXLE HUB NUT Installation

8. INSTALL FRONT SPEED SENSOR LH Installation

9. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Service and Repair.