Rear Stabilizer Bar

SUSPENSION: REAR STABILIZER BAR: INSPECTION

1. INSPECT REAR STABILIZER LINK ASSEMBLY LH





(a) As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.05 to 1.96 N*m, (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf) or less

(c) Check for any cracks and grease leaks on the ball joint dust cover.