Reassembly

U241E AUTOMATIC TRANSAXLE: OIL PUMP: REASSEMBLY

1. INSTALL FRONT OIL PUMP OIL SEAL

(a) Using SST, install a new oil seal to the pump.





SST : 09350-32014

09351-32140

HINT
The seal end should be flush with the outer edge of the oil pump.

(b) Coat the lip of the oil seal with petroleum jelly.

2. INSTALL FRONT OIL PUMP BODY O-RING

(a) Coat a new O-ring with ATF, and install it to the oil pump body.





3. INSTALL FRONT OIL PUMP DRIVEN GEAR

(a) Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing up.





4. INSTALL FRONT OIL PUMP DRIVE GEAR

(a) Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.





5. INSTALL STATOR SHAFT ASSEMBLY

(a) Set stator shaft by aligning each bolt hole.





(b) Using a T30 ''TORX'' socket, install the 11 bolts.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

6. INSTALL CLUTCH DRUM OIL SEAL RING





NOTICE:
Do not expand the ring ends excessively.

(a) Install the 2 clutch drum oil seal rings.

7. INSPECT OIL PUMP ASSEMBLY Oil Pump