Programming and Relearning

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: INITIALIZATION

CAUTION:
When the power window regulator motor assembly (on the driver side) is reinstalled or replaced, the power window control system must be initialized. Functions such as the AUTO UP / DOWN, jam protection and key-off do not operate if the initialization is not performed.

NOTICE:
* When the power window regulator motor assembly (on the driver side) is replaced, DTC B2313 is output. Clear the DTC after the initialization.
* When the initialization cannot be completed successfully, LIN communication problems are a possible cause, therefore the LIN system needs to be inspected.
* When performing initialization, do not perform any other procedures.
* After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used, due to detection of the different operation learned value of the door glass movement speed. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
* Open the power window by fully pushing down the switch.
* Close the power window by fully pulling up the power window switch and holding it at the AUTO UP position.
1. INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR ASSEMBLY (ON DRIVER SIDE))

HINT
By resetting the door glass position of the driver door power window (the pulse sensor), the power window regulator motor (on the driver side) is initialized.

(a) Connect the battery and turn the ignition switch ON.

(b) The AUTO Light of the power window regulator master switch flashes when the initialization preparation is complete.

(c) *1: Fully open the driver door power window by pressing down the driver door power window switch, and continue pressing it for at least 1 second after the window is fully opened.

(d) *2: Fully close the driver door power window by pulling up the switch, and continue pulling it up for at least 1 second after the window is fully closed.

(e) The driver door power window position is reset (the pulse sensor is initialized), and the power window regulator master switch AUTO Light changes from flashing to continuous illumination to indicate that the initialization has been successfully completed.

HINT
If the AUTO Light does not change to continuous illumination, even when step *2 is finished, repeat the procedure from step *1.