Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE PEDAL ASSEMBLY

(a) Install the parking brake pedal assembly with the 3 nuts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(b) Connect the parking brake switch connector.

Nut - Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

Bolt - Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

(d) Temporarily install the No. 1 wire adjusting nut and lock nut.

Text in Illustration:

HINT
After adjusting parking brake pedal travel, tighten the lock nut.

(e) Engage the 4 clamps to install the wire harness.

(f) Connect the 2 connectors.

(g) Connect the heated oxygen sensor connector and engage the 2 clamps (for 2GR-FE).

2. CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY

(a) Holding the lock nut of the No. 1 parking brake cable assembly, tighten the turnbuckle of the No. 4 parking brake cable assembly to connect the No. 4 parking brake cable assembly to the No. 1 parking brake cable assembly.

Text in Illustration:

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL FRONT NO. 2 FLOOR SILENCER

(a) Install the front No. 2 floor silencer.

4. INSTALL REAR NO. 1 AIR DUCT Installation

5. INSTALL REAR NO. 2 AIR DUCT Installation

6. INSTALL YAW RATE AND ACCELERATION SENSOR

HINT
Refer to the instructions for Installation of the yaw rate and acceleration sensor Installation.

7. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL Adjustments

8. INSPECT BRAKE WARNING LIGHT Adjustments