Reading and Clearing Diagnostic Trouble Codes

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: DTC CHECK / CLEAR

1. DTC CHECK (USING SST CHECK WIRE)

(a) Turn the ignition switch off.





(b) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST : 09843-18040

(c) Turn the ignition switch to ON.

(d) Read and record any DTCs from the tire pressure warning light on the accessory meter. Refer to the illustration as examples of the normal system code and codes 13 and 23.

HINT
* If the tire pressure warning light does not indicate any DTCs or does not flash, inspect the tire pressure warning light circuit or TC and CG terminal circuit.






* If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
(e) Refer to the Diagnostic Trouble Code Chart for DTC information Tire Pressure Warning System.

(f) After completing the check, turn the ignition switch off and remove SST from the DLC3.

SST : 09843-18040

2. DTC CHECK (USING TECHSTREAM)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

(f) Read the DTCs following the prompts on the Techstream.

3. CLEAR DTC

HINT
After repairing the malfunctions, clear the DTCs.

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

(f) Clear the DTCs following the prompts on the Techstream.

HINT
Refer to the Techstream operator's manual for further details.