Installation

2TR-FE ENGINE MECHANICAL: ENGINE UNIT: INSTALLATION

1. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET RH

(a) Install the engine mounting bracket with the 4 bolts.

Torque : 51 Nm (520 kgf-cm, 38 ft-lbf)

2. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH

(a) Install the engine mounting bracket with the 4 bolts.

Torque : 51 Nm (520 kgf-cm, 38 ft-lbf)

3. INSTALL FRONT ENGINE MOUNTING INSULATOR

(a) Install the 2 mounting insulators with the 2 nuts.

Torque : 46 Nm (469 kgf-cm, 34 ft-lbf)

4. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

(a) Install the oil level dipstick guide with the bolt.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

5. INSTALL NO. 1 WATER BY-PASS PIPE

(a) Install a new gasket and the water by-pass pipe with the 2 nuts.

Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

6. INSTALL NO. 1 IDLER PULLEY SUB-ASSEMBLY Installation

7. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET Installation

8. INSTALL INTAKE MANIFOLD Installation

9. INSTALL PURGE VSV Installation

10. INSTALL FUEL DELIVERY PIPE WITH FUEL INJECTOR

(a) Install the fuel delivery pipe with fuel injector Installation.

11. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY Installation

12. INSTALL EXHAUST MANIFOLD Installation

13. INSTALL AIR SWITCHING VALVE ASSEMBLY Installation

14. INSTALL NO. 4 INTAKE PIPE Installation

15. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

16. INSTALL GENERATOR ASSEMBLY Installation

17. INSTALL IGNITION COIL ASSEMBLY Installation