Installation

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR

(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(b) Connect the 2 knock control sensor connectors.

2. INSTALL INTAKE MANIFOLD Installation

3. INSTALL NO. 2 ENGINE MOUNTING STAY RH Installation

4. CONNECT FUEL MAIN TUBE Installation

5. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY Installation

6. TEMPORARILY INSTALL THROTTLE BODY BRACKET Installation

7. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

8. FULLY TIGHTEN NO. 1 SURGE TANK STAY Installation

9. FULLY TIGHTEN THROTTLE BODY BRACKET Installation

10. CONNECT ENGINE ROOM WIRE Installation

11. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

12. ADD ENGINE COOLANT Service and Repair

13. INSPECT FOR COOLANT LEAK Testing and Inspection

14. INSPECT FOR FUEL LEAK Fuel System

15. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

16. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Installation

17. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

18. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

19. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

20. INSTALL NO. 1 ENGINE UNDER COVER Installation

21. INSTALL ENGINE UNDER COVER ASSEMBLY Installation

22. INSTALL V-BANK COVER SUB-ASSEMBLY Installation