Removal

2AZ-FE ENGINE CONTROL: ECM: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Removal

4. REMOVE AIR CLEANER CASE Removal

5. REMOVE ECM

(a) Separate the wire harness clamp.





(b) Disconnect the 2 ECM connectors.

(1) Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.





NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

(c) Remove the 3 bolts and the ECM.





(d) Remove the 4 screws and 2 ECM brackets.