Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL Disassembly

3. REMOVE FRONT ARMREST UPPER BASE PANEL Disassembly

4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

5. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly

6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Front No. 2 Speaker) Disassembly

7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Front No. 2 Speaker) Disassembly

8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP Disassembly

9. REMOVE FRONT DOOR SERVICE HOLE COVER (w/o Power Door Lock) Disassembly

10. REMOVE FRONT DOOR SERVICE HOLE COVER (w/ Power Door Lock) Disassembly

11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

12. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly

13. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a "TORX" driver (T25), remove the 3 screws and the front power window regulator motor assembly.