Removal

SEAT: REAR SEAT RECLINING CONTROL CABLE: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

4. REMOVE REAR SEAT CUSHION LOCK HOOK Removal

5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD Removal

6. REMOVE REAR SEATBACK ASSEMBLY LH Removal

7. REMOVE REAR SEATBACK ASSEMBLY RH Removal

8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH Removal

9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH Removal

10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal

11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Removal

12. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) Removal

13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) Removal

14. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH Removal

15. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH Removal

16. REMOVE ROOF SIDE INNER GARNISH LH Removal

17. REMOVE ROOF SIDE INNER GARNISH RH

HINT
Use the same procedure as for the LH side Removal.

18. REMOVE CENTER STOP LIGHT SET Removal

19. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER Removal

20. REMOVE REAR SEAT SHOULDER BELT COVER Removal

21. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY Removal

22. REMOVE ROOM PARTITION BOARD LH

(a) Disengage the guide, 2 claws and 4 clips, and remove the room partition board LH.





23. REMOVE ROOM PARTITION BOARD RH

(a) Using a clip remover, remove the 2 clips.





(b) Disengage the 5 clips and remove the room partition board RH.

24. REMOVE REAR SEATBACK LOCK ASSEMBLY LH (REAR SEAT LOCK CONTROL CABLE LH)

(a) Disengage the hook as shown in the illustration.





(b) Remove the 2 nuts and rear seatback lock assembly LH (rear seat lock control cable LH).





25. REMOVE REAR SEATBACK LOCK ASSEMBLY RH (REAR SEAT LOCK CONTROL CABLE RH)

HINT
Use the same procedure as for the LH side.