Air Conditioning Compressor Magnetic Clutch Circuit

HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Manual Air Conditioning System): Air Conditioning Compressor Magnetic Clutch Circuit
- Air Conditioning Compressor Magnetic Clutch Circuit

DESCRIPTION

When the air conditioning amplifier assembly is turned on, a magnetic clutch on signal is sent from the MGC terminal of the air conditioning amplifier assembly. Then, the engine room junction block assembly turns on to operate the magnetic clutch assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK ENGINE ROOM JUNCTION BLOCK ASSEMBLY

(a) Using a voltmeter, check the signal reading of the engine room junction block assembly Testing and Inspection.

OK:

A normal signal reading is output.

NG -- INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (RESULT OF SIGNAL READING CHECK) Testing and Inspection
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (ENGINE ROOM RELAY BLOCK ASSEMBLY POWER SOURCE AND BODY GROUND)

(a) Remove the engine room junction block assembly from the engine room relay block and junction block assembly Removal.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - MAGNETIC CLUTCH ASSEMBLY)

(a) Remove the engine room junction block assembly Removal.

(b) Disconnect the E73 cooler compressor assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. INSPECT COOLER COMPRESSOR ASSEMBLY

(a) Disconnect the a2 magnetic clutch assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPLACE COOLER COMPRESSOR ASSEMBLY Removal
OK -- Continue to next step.

5. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY

(a) Disconnect the I77 air conditioning amplifier assembly connector.

(b) Reconnect the engine room junction block assembly connector.

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

NG -- CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - ENGINE ROOM JUNCTION BLOCK ASSEMBLY)
OK -- Continue to next step.

6. INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY

(a) Reconnect the I77 air conditioning amplifier assembly connector.

(b) Measure the voltage and voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Air Conditioning System (for Manual Air Conditioning System)

7. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - ENGINE ROOM JUNCTION BLOCK ASSEMBLY)

(a) Measure the voltage and resistance according to the value(s) in the table below.

Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE ENGINE ROOM JUNCTION BLOCK ASSEMBLY Removal