Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION
1. INSTALL OCCUPANT DETECTION ECU
(a) Engage the claw to install the occupant detection ECU.
NOTICE:
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
(b) Connect the 2 connectors.
NOTICE:
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT
Use the same procedure for the RH side and LH side.
* for TMMK Made Manual Seat: Installation
* for SIA Made Manual Seat: Installation
* for TMMK Made Power Seat: Installation
* for SIA Made Power Seat: Installation
3. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
Programming and Relearning