Removal

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: REMOVAL

HINT
The type of tire pressure warning ECU and receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.





1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

4. REMOVE REAR SEAT CUSHION LOCK HOOK Removal

5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH Removal

6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Removal

7. REMOVE ROOF SIDE INNER GARNISH RH

HINT
Use the same procedure as for the LH side Removal.

8. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

(a) Remove the bolt.





(b) Disengage the 2 tabs from the holes to remove the tire pressure warning ECU and receiver.

(c) Disconnect the connector from the tire pressure warning ECU and receiver.