2AR-FE with Wireless Door Lock

POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for 2AR-FE with Wireless Door Lock): CALIBRATION

1. TORQUE SENSOR ZERO POINT CALIBRATION

NOTICE:
Perform torque sensor zero point calibration if any of the following conditions occur:

* The power steering ECU assembly has been replaced.
* The electric power steering column sub-assembly has been replaced.
* There is a difference in steering effort between turning left and right.

(a) Inspection before calibration

(1) Turn the ignition switch off.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to ON.

(4) Turn the Techstream on.

(5) Calibrate the power steering ECU assembly. Enter the following menus: Chassis / EMPS / Data List.

(6) Check the values by referring to the table below.

EMPS





Standard Voltage:

9 to 16 V

NOTICE:
If the IG power supply voltage is 9 V or less, calibration cannot be performed. In this case, charge or replace the battery, and then perform calibration.

(b) Torque sensor zero point calibration

NOTICE:
If DTC C1516 (Torque Sensor Zero Point Adjustment Incomplete) is stored, the torque sensor zero point cannot be calibrated. Clear the DTCs before starting calibration.

(1) Set the steering wheel to the center point and align the front wheels straight ahead.

(2) Turn the ignition switch off.

(3) Connect the Techstream to the DLC3.

(4) Turn the ignition switch to ON.

(5) Turn the Techstream on.

(6) Enter the following menus: Chassis / EMPS / Utility / Torque Sensor Adjustment.

NOTICE:
* Do not turn the steering wheel sharply.
* Do not touch the steering wheel during torque sensor zero point calibration (for 3 seconds).

(7) Check for DTCs 2AR-FE with Wireless Door Lock.

NOTICE:
If DTC C1515, C1516, C1534 or C1581 is output, perform troubleshooting for the corresponding DTC.

Result:





2. ASSIST MAP WRITING

HINT
If DTC C1581 is output after torque sensor zero point calibration, perform assist map writing.

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Utility / Signal Check.

HINT
* Follow the instructions on the Techstream to perform Signal Check.
* With DTC C1581 output, performing Signal Check will cause the power steering ECU assembly to enter Test Mode and the assist map will be written automatically.

(f) Wait for at least 5 second.

(g) Check for DTCs 2AR-FE with Wireless Door Lock.

HINT
After writing the assist map, if DTC C1581 is output, perform the troubleshooting procedure for DTC C1581 2AR-FE with Wireless Door Lock.