Installation

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT PADDLE SWITCH: INSTALLATION

NOTICE:
* Do not replace the spiral cable with the battery connected and the ignition switch to ON.
* Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch to ON.
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
* Do not remove the steering sensor from the spiral cable.

1. CONNECT NO. 1 SWITCH WIRE

(a) Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).

(b) Install new 2 clamps as shown in the illustration.





Text in Illustration





(c) Engage the 5 guides to install the No. 1 switch wire.

2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

(a) Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

Torque : 1.3 Nm (13 kgf-cm, 12 in-lbf)

NOTICE:
Make sure that the brackets are securely installed.

3. INSTALL STEERING PAD SWITCH ASSEMBLY Installation

4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

6. INSTALL STEERING WHEEL ASSEMBLY Installation

7. CHECK STEERING WHEEL CENTER POINT

8. INSTALL HORN BUTTON ASSEMBLY

Installation