Removal

BRAKE CONTROL: FRONT SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.
for 2GR-FE: Removal
for 1AR-FE: Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT WHEEL

3. REMOVE FRONT FENDER LINER

Removal

4. REMOVE FRONT SPEED SENSOR

(a) Disconnect the front speed sensor connector and remove the 2 clamps.





(b) Remove the bolt and No. 2 sensor clamp from the body.





(c) Remove the bolt, No. 1 sensor clamp, and flexible hose together from the shock absorber assembly.





(d) Remove the bolt, resin clamp, and the front speed sensor.





NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the installation hole and the contact surface for the front speed sensor every time it is removed.