Certification ECU Power Source Circuit

ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM (w/ Smart Key System): Certification ECU Power Source Circuit
- Certification ECU Power Source Circuit

DESCRIPTION

This is the power source circuit of the certification ECU (smart key ECU assembly).

The certification ECU (smart key ECU assembly) controls the following:

* Electrical key verification confirmation

* Indoor, outside and door oscillator control

* Entry door LOCK/UNLOCK request to the main body ECU (instrument panel junction block)

* Steering LOCK/UNLOCK request

* Immobiliser SET/UNSET request to the ID code box (immobiliser code ECU)

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID Engine Immobilizer System (w/ Smart Key System).

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY)

(a) Disconnect the certification ECU (smart key ECU assembly) connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal