Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2012 >> Highlander 2WD V6-3.5L (2GR-FE) >> Repair and Diagnosis >> Accessories and Optional Equipment >> Navigation System >> Testing and Inspection >> Component Tests and General Diagnostics >> Sound Signal Circuit Between Navigation Receiver Assembly and Multi-media Interface ECU
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Sound Signal Circuit Between Navigation Receiver Assembly and Multi-media Interface ECU





NAVIGATION: NAVIGATION SYSTEM: Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU
- Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU

DESCRIPTION

The multi-media interface ECU sends USB audio sound signals or satellite radio sound or RSE sound*1 signals to the navigation receiver assembly via the sound signal circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the television display assembly*1, stereo component amplifier assembly, navigation receiver assembly or speakers.

* *1: w/ Rear Seat Entertainment System

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)

(a) Disconnect the E15 navigation receiver assembly connector.

(b) Disconnect the E30 multi-media interface ECU connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table
pro multis · About Operation CHARM