Installation

E351 MANUAL TRANSMISSION / TRANSAXLE: BACK-UP LIGHT SWITCH: INSTALLATION

1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

(a) Using SST, install the back-up light switch and a new gasket to the transaxle case.





SST : 09817-16011

Torque : 40 Nm (410 kgf-cm, 30 ft-lbf)

(b) Connect the back-up light switch connector.





2. CONNECT WIRE HARNESS

(a) Connect the wire harness to the wire harness clamp.





(b) Connect the terminal 50 connector to the starter assembly.





(c) Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

3. INSTALL AIR CLEANER CASE Installation

4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation