B2005

PRE-COLLISION: PRE-COLLISION SYSTEM: B2005: Short to B+ in Seat Belt Motor LH Circuit
B2005 - Short to B+ in Seat Belt Motor LH Circuit

DESCRIPTION

The seat belt control ECU receives information from the driving support ECU assembly using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly LH.





WIRING DIAGRAM





INSPECTION PROCEDURE

CAUTION:
The pretensioner is built into the front seat outer belt assembly LH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

PROCEDURE

1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH

(a) Disconnect the R8 front seat outer belt assembly LH connector.





HINT
Do not remove the front seat outer belt assembly LH.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





CAUTION:
Do not check a wrong connector.

NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH Removal
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)

(a) Disconnect the L2 seat belt control ECU connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)

OK -- REPLACE SEAT BELT CONTROL ECU Removal