Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure described below is for the LH side.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE DECK BOARD ASSEMBLY Removal

3. REMOVE NO. 1 DECK BOARD Removal

4. REMOVE NO. 2 DECK BOARD Removal

5. REMOVE REAR DECK FLOOR BOX Removal

6. REMOVE DECK FLOOR BOX RH Removal

7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE FRONT DOOR SCUFF PLATE Removal

9. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Disconnect the front door opening trim weatherstrip.

10. REMOVE REAR DOOR SCUFF PLATE Removal

11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

(a) Disconnect the rear door opening trim weatherstrip.

12. REMOVE LAP BELT OUTER ANCHOR COVER

(a) Disengage the 3 claws and remove the lap belt outer anchor cover.





13. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the bolt and disconnect the floor end of the front seat outer belt assembly.





14. REMOVE CENTER PILLAR LOWER GARNISH Removal

15. REMOVE CENTER PILLAR GARNISH Removal

16. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.





(b) Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.





Text in Illustration





HINT
Tape the screwdriver tip before use.

(c) Disconnect the connector.

(d) w/ Pre-collision System:

(1) Disconnect the connector.

(e) Remove the 2 bolts and front seat outer belt assembly.





17. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Remove the 2 bolts.





(b) Disengage the guide and remove the front shoulder belt anchor adjuster assembly.