Removal

DOOR LOCK: FRONT DOOR LOCK: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE DECK BOARD ASSEMBLY Removal

3. REMOVE NO. 1 DECK BOARD Removal

4. REMOVE NO. 2 DECK BOARD Removal

5. REMOVE REAR DECK FLOOR BOX Removal

6. REMOVE DECK FLOOR BOX RH Removal

7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

9. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

10. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Disassembly

11. REMOVE DOOR ARMREST COVER Disassembly

12. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

13. REMOVE FRONT DOOR TRIM BRACKET Disassembly

14. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly

15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

16. REMOVE FRONT DOOR GLASS RUN Disassembly

17. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY Disassembly

18. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side) Disassembly

19. REMOVE FRONT DOOR LOCK ASSEMBLY

(a) Disconnect the connector.





Text in Illustration





(b) Using a T30 "TORX" socket wrench, remove the 3 screws.

(c) Move the front door lock assembly downward and disconnect the front door lock open rod, and then remove the front door lock assembly.

(d) When reusing the front door lock assembly:





(1) Remove the door lock wiring harness seal from the front door lock assembly.

(e) Remove the front door lock remote control cable assembly from the front door lock assembly.





(f) Using a screwdriver, disengage the 3 claws.





(g) Remove the front door inside locking cable assembly from the front door lock assembly.