Installation

HYBRID / BATTERY CONTROL: HV RELAY ASSEMBLY: INSTALLATION

1. INSTALL HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:
Be sure to wear insulated gloves.

(a) Install the hybrid battery junction block assembly with the 3 nuts.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

(b) Connect the 4 connectors to the hybrid battery junction block assembly.

NOTICE:
The connectors should be connected securely.

2. CONNECT FRAME WIRE Installation

3. CHECK HIGH VOLTAGE CABLE CONNECTION Installation

4. INSTALL UPPER HYBRID BATTERY COVER SUB-ASSEMBLY Installation

5. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT Installation

6. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT Installation

7. INSTALL REAR SEAT ASSEMBLY RH

Installation

8. INSTALL REAR NO. 1 FLOOR BOARD Installation

9. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation

10. INSTALL SERVICE PLUG GRIP

Installation