Removal

HYBRID / BATTERY CONTROL: HV RELAY ASSEMBLY: REMOVAL

1. PRECAUTION

Service Precautions

2. REMOVE SERVICE PLUG GRIP

Removal

3. REMOVE INVERTER COVER Removal

4. CHECK TERMINAL VOLTAGE Removal

5. INSTALL INVERTER COVER Installation

6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Removal

7. REMOVE REAR NO. 1 FLOOR BOARD Removal

8. REMOVE REAR SEAT ASSEMBLY RH

Removal

9. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT Removal

10. REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT Removal

11. REMOVE UPPER HYBRID BATTERY COVER SUB-ASSEMBLY Removal

12. DISCONNECT FRAME WIRE Removal

13. REMOVE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:
Be sure to wear insulated gloves.

NOTICE:
Insulate the disconnected terminals with insulating tape.

(a) Disconnect the 2 connectors from the hybrid battery junction block assembly.

(b) Disconnect the 2 connectors from the hybrid battery junction block assembly.